Inductive sensor NJ10-30GM50-E2-V1-3G-3D
Описание
Информация для заказа
General specifications | |
|---|---|
| Switching function | Normally open (NO) |
| Output type | PNP |
| Rated operating distance | 10 mm |
| Installation | flush |
| Output polarity | DC |
| Assured operating distance | 0 ... 8.1 mm |
| Actual operating distance | 9 ... 11 mm typ. 10 mm |
| Reduction factor rAl | 0.32 |
| Reduction factor rCu | 0.32 |
| Reduction factor r304 | 0.72 |
| Reduction factor rBrass | 0.43 |
Nominal ratings | |
| Operating voltage | 10 ... 60 V DC |
| Switching frequency | 0 ... 650 Hz |
| Hysteresis | 1 ... 15 typ. 5 % |
| Reverse polarity protection | reverse polarity protected |
| Short-circuit protection | pulsing |
| Voltage drop | ? 2.8 V |
| Voltage drop at IL | |
| Operating current | 0 ... 200 mA |
| Off-state current | 0 ... 0.5 mA typ. 0.01 mA |
| No-load supply current | ? 9 mA |
| Switching state indicator | LED, yellow |
Functional safety related parameters | |
| MTTFd | 1220 a |
| Mission Time (TM) | 20 a |
| Diagnostic Coverage (DC) | 0 % |
Approvals and certificates | |
| UL approval | cULus Listed, General Purpose |
| CSA approval | cCSAus Listed, General Purpose |
| CCC approval | Certified by China Compulsory Certification (CCC) |
Ambient conditions | |
| Ambient temperature | -25 ... 70 °C (-13 ... 158 °F) |
| Storage temperature | -25 ... 85 °C (-13 ... 185 °F) |
Mechanical specifications | |
| Connection type | Connector M12 x 1 , 4-pin |
| Housing material | Stainless steel 1.4305 / AISI 303 |
| Sensing face | PBT |
| Housing diameter | 30 mm |
| Degree of protection | IP67 |
Equipment protection level Gc (nA) | |
| Certificate of Compliance | PF 15CERT3754 X |
| Special conditions | |
Equipment protection level Dc (tc) | |
| Instruction | Manual electrical apparatus for hazardous areas |
| Device category 3D | for use in hazardous areas with combustible dust |
| Certificate of Compliance | PF 15CERT3774 X |
| CE marking | [*PD-Z02586A*] |
| ATEX marking |  II 3D Ex tc IIIC T80°C Dc The Ex-related marking can also be printed on the enclosed label. |
| Standards | EN 60079-0:2012+A11:2013, EN 60079-31:2014 Protection by enclosure "tc" Some of the information in this instruction manual is more specific than the information provided in the datasheet. |
| General | The corresponding datasheets, declarations of conformity, EC-type examination certificates, certifications, and control drawings, where applicable (see datasheets), form an integral part of this document. These documents can be found at www.pepperl-fuchs.com. The maximum surface temperature of the device was determined without a layer of dust on the apparatus. Some of the information in this instruction manual is more specific than the information provided in the datasheet. |
| Installation, commissioning | |
General specifications- Цена: Цену уточняйте
Информация для покупателя
ООО «ФилФар Технолоджи»
220036, г. Минск, ул. Западная, д.13, к.519
Дата регистрации в Торговом реестре/Реестре бытовых услуг: 18.03.2015
Номер в Торговом реестре/Реестре бытовых услуг: 220993, Республика Беларусь
УНП: 192123248
Регистрационный орган: Минский горисполком
Дата регистрации компании: 18.09.2013
Ссылка на свидетельство/лицензию
Режим работы:
| День | Время работы |
|---|---|
| Понедельник | 09:00-17:00 |
| Вторник | 09:00-17:00 |
| Среда | 09:00-17:00 |
| Четверг | 09:00-17:00 |
| Пятница | 09:00-17:00 |
| Суббота | Выходной |
| Воскресенье | Выходной |