OOO "ФилФар Технолоджи"

101172168 | SE-P70-2500

  101172168 | SE-P70-2500
Под заказТолько оптом

Цену уточняйте

  • +375 показать номер +375(44)765-55-50
  • +375(29)690-11-55

Заказ только по телефону

  • Контакты
    • Телефон:
    • Контактное лицо:
      Сергей, Владимир
    • Адрес:
      ул. Западная, д.13, каб.519, Минск, Беларусь
    • Email:

Техническая спецификация в PDF  

Ordering details

Product type descriptionSE-P70-2500
Article number101172168
EAN Code4030661300245
A safety edge system consists of individual components.
The components must be ordered separately.
Rubber profile, SE-P70-1250
Al profile, SE-AL 20-1250
Emitter/ Receiver SE-SET
Safety-monitoring module, SE-304 C

Caps SE-T70; Sticker SE-G8406
Other accessories


Approval TÜV

Global Properties

Permanent lightGummiprofil SE-P70
StandardsEN ISO 13850
Compliance with the Directives (Y/N) Yes
- Material of the rubber profileEPDM, 65 Shore A
Resistant to chemicals of the rubber material
- International abbreviationEPDM, 65 Shore A
- Chemical nameEthylene-propylene terpolymer
- Resilience at 20°CGood
- Resistance against permanent deformationGood
- General resistance against atmospheric conditionsExcellent
- Resistance against ozoneExcellent
- Resistance against oillow
- Resistance against fuellow
- Resistance against solventslow to satisfactory
- General resistance against acidsGood
Coated profile (Y/N)No

Mechanical data

Mechanical life20.000.000 operations
max. permanent load500 on the operational switching zone
Response travelmax. 9 mm
After-travelmax. 18 mm

Ambient conditions

Temperature resistance
- min. Temperature resistance−50 short duration
−30 long duration
- max. Temperature resistance+170 short duration
+140 long duration
Protection classIP67
noticeThe protection class IP 67 applies to the entire signal transmitter.


- Width25 mm
- Heightapprox. 70 mm
- Length2500 mm


If a higher resistance is required, choose safety edge profiles with 20 µm plastic coating. The coating must be submitted to low mechanical loads only.
In the extremities of the safety edge at approx. 60 mm (SE 40) or 50 mm (SE 70) finger guard is not guaranteed. Upon actuation of this area, the transmitter/receiver is pushed into the lower profile section and the switching signal is evaluated, but the required forces are high though.
If this restriction is not acceptable for the specific application, constructive measures must be taken.


По вопросу интересующей Вас продукции, пожалуйста, свяжитесь с нами:


8 (029) 555-8-000


8 (044) 555-8-000


8 (017) 255-8-000

Или отправьте нам запрос на e-mail:


Информация для заказа
  • Цена: Цену уточняйте
  • Телефон:
  • Контактное лицо:
    Сергей, Владимир
  • Адрес:
    ул. Западная, д.13, каб.519, Минск, Беларусь
  • Email: